Trace Power Panel Pre-built Systems for Solar,Wind Renewable Energy Economy

Alternative energy power systems, components and design assistance.

JATS Alternative Power Company
Advanced Energy Group authorized dealer

Power Panel Systems

Pre-built System Balance.

solar power system inverter and control panel by Trace

Finally a Low Cost Alternative to Assembling Components in the Field. Power Panels are Trace's first packaged power system. They are less expensive than an on-site component installation and meet many power application needs. To install a Power Panel, simply connect them to the battery, PV and or AC loads. Power Panels include inverters and are assembled by Trace with components specified at the time they're ordered.

Included in all Power Panel Systems:

Powder-coated steel backplate prewired with all NEC / UL required AC & DC overcurrent protection and disconnects (only for indoor installation). Simply connect to the battery and AC loads and your system is operational.

Can be used with wind, solar, or hydro DC charging sources
60 amp AC system bypass that allows inverter servicing while keeping AC loads connected to the grid or generator

Flexible conduit for connection of the system to the battery enclosure

ETL listed components and enclosure

Negative/ground bonding block

SW Series Power Panels

               Sine wave AC power inverter with high-efficiency, bidirectional operation
               Up to 11 kW of continuous AC power
               Up to 60 amps of AC input from a generator or utility grid
               Three-stage, temperature-compensated battery charging
               (up to 300A @ 12VDC, 240A @ 24 VDC, and 150A @ 48 VDC)
               Utility-interactive and generator-support operating modes
               Able to regulate up to 4.8 kW of power from solar or other DC charging sources
               Available outputs of 105, 120, 230 or 120/240 vac at 50 or 60 Hz.
               Available for a 12, 24 or 48-volt DC system

DR Series Power Panels

Modified sine wave AC power inverter with high-efficiency operation and battery charging ability
Up to 7.2 kW of continuous AC power (120/240 vac systems)

30 amps of AC pass through power at 120 or 120/240 vac from a generator or utility grid to your loads, in addition to the charger draw

Three-stage, temperature-compensated battery charging - up to 240A @ 12 VDC or 140A @ 24 VDC
Able to regulate up to 2.4 kW of power from solar or other DC charging sources
Available outputs of 105, 120, 230 or 120/240 vac at 50 or 60 Hz
Available for 12 or 24-volt DC system

SW and DR Options

               Optional nonmetallic battery enclosure which doubles as a shipping enclosure
               Single or dual C40 Charge controllers for solar, wind, hydro DC charging sources
               One or two Trace SW or DR inverters

           Note: Products are listed by UL and/or ETL to UL specifications
                      Year 2000 Note: Trace products do not utilize date sensitive chips.
                      Therefore inverters and other Trace equipment are not susceptible
                      to Year 2000 complications.

Trace Inverters

Complete Trace product line